Your old mappings will be broken, your new mappings will not be saved, etc. When corrupted, Cakewalk can't use these files but it does not report that. If ACTFix report "corruption", restore from backup. Here you can reset/rearrange/etc the mapping.Īfter learning some plug-ins using 1-2, I strongly recommend close Cakewalk, open ACTFix and just "Save" to make a backup. Switch to "AZ Controller" mapping (combo-box on top). It can be you can't ACT learn (also happens with Cakewalk plug-ins), or your current mapping is a mess and you want start from scratch, you want re-arrange mapping, etc. This way you see current mapping, so "strategical planning" is simpler. You can use the procedure of (1) but "pressing" buttons in the "Faders" column instead of touching M32 knobs (remember you have 4 banks, so 32 faders in total). Focus plug-in in question, you should see current mapping.
Open AZ Controller UI, switch to ACT Tab.
If not, parameters you wanted are not "learnable" (see method (3)) Modify some plug-in parameters in sequence (using mouse), then turn M32 knobs (in ACT mode) in the same sequence. You press ACT Learn button "A L" (if you are learning FX it is right there, if you are learning PC Module use one on ACT top bar module). That is why I write partially.īy default when there is no mapping (after deleting all XMLs) everything is mapped to "ACT knobs". With this preset M32 controls so called "ACT faders" only, delivered mappings are primary for 8+8+8 Faders/Knobs/Buttons.
It can be some of them was partially usable. In pre-installed XMLs there was "some" mappings.
0 kommentar(er)
